Filter
Top Products
STEP 9 (See Diagram 9 & Cable Loop Diagram)
A.) Attach the end of the 115” Front Press Cable (#43) to the open bracket on the Left
Vertical Beam (#17). Secure it with one M10 x 1” Allen Bolt (#81), two Ø ¾” Washers
(#94), and one M10 Aircraft Nut (#97).
B.) Draw the Cable to the opening on the Front Press Base (#19). Attach a Pulley to the
opening. Secure the Pulley to the Front Press Base with one M10 x 5 1/8” Allen Bolt
(#86), two Ø ¾” Washers (#94), and one M10 Aircraft Nut (#97).
C.) Draw the Cable around the Pulley then back to the opening on the Left Vertical Beam
to the open bracket underneath the Left Upper Frame (#18). Attach a Pulley to the
bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#82), two Ø ¾” Washers (#94), and
one M10 Aircraft Nut (#97).
D.) Draw the Cable around the Pulley then downward. Install a Pulley to two Flat Double
Floating Pulley Brackets (#36). Draw the Cable around the Pulley then upward to the
open bracket on the Left Upper Frame. Let the Bracket hanging for now.
E.) Install a Small Pulley (#61) to the bracket with a 2 ½” L-shaped Cable Retainer (#34).
F.) Draw the Cable over the Small Pulley then to the open bracket on the Guide Rod
Upper Frame (#11). Install a Small Pulley to the bracket with a 2 ½” L-shaped Cable
Retainer (#34).
G.) Draw the Cable around the Small Pulley then downward to the Selector Rod (#13).
Thread the Bolt at the end of the Cable into the Selector Rod. Use the Nut on the Bolt
to secure the Bolt into the Rod.
18