Filter
Top Products
15
ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE
To use the upper or lower pulley stations, slide the
desired amount of weight (not included) onto the weight
tube of the Weight Carriage (47). Secure the weights with
Weight Clips (50).
47
Weight
Tube
WARNING: Do not place more than 150 pounds on
the Weight Carriage. Always place the same
amount of weight (not included) on each side of
the Weight Carriage. Always secure the weights
with the Weight Clips (50).
ATTACHING THE CURL POST TO THE FRONT LEG
OR USING IT AS A SEAT
To use the Curl Pad (44), insert the Curl Post (42) into the
Front Leg (19) and line up one of the adjustment holes in
the Curl Post with the hole in the Front Leg. Insert the
Adjustment Knob (36) through the Curl Post and tighten it
into the welded nut on the Front Leg.
For certain exercises, the Curl Pad (44) can be used as a
seat. To do this, turn the Curl Pad around, compared to
the picture, and mount it on the storage tube on the Right
Upright (2). The Curl Pad can also be stored here when it
is not in use.
42
44
19
36
2
Storage
Tube
ATTACHING THE LAT BAR OR NYLON STRAP TO
THE UPPER OR LOWER PULLEY STATIONS
To use the upper pulley station, attach the Lat Bar (46) or
the Nylon Strap (73) to the Upper Cable (45) with the
Cable Clip (40). The Lat Bar or Nylon Strap can be
attached to the lower pulley station in the same manner.
Other attachments, such as an ankle strap, can be
attached to the pulley stations as described above.
IMPORTANT: See assembly step 12 on page 10 for
information on how to tighten the cables.
45
40
46
73
LOCKING THE LEG LEVER
The Leg Lever (18) can be locked by rotating the Leg
Lever Lock (41) until it snaps into place over the Pad
Tube (38). Note: A Foam Pad has been removed for
clarity; it does not have to be removed to lock the
Leg Lever.
38
18
41
50
50