Filter
Top Products
11
13. Insert two M10 x 68mm Bolts (33) into the 2-hole
Support Plate (70), the Front Leg (19), and the brack-
et on the Bench Frame (5) as shown. Tighten an M10
Nylon Locknut (11) onto each Bolt.
13
33
11
11
5
70
19
14. Align the bracket on the Bench Frame (5) with the
holes in the center of the Crossbar (20). Attach the
Bench Frame (5) to the Crossbar with two M10 x
68mm Bolts (33) and two M10 Nylon Locknuts (11).
14
11
5
20
33
15. Attach the Leg Lever Lock (41) to the indicated hole
in the Front Leg (19) with an M8 x 64mm Bolt (43),
two M8 Washers (23), and an M8 Nylon Locknut (13).
Do not overtighten the Nylon Locknut; the Leg
Lever Lock must pivot easily.
Attach the Bumper (48) to the indicated hole in the
Front Leg (19) with a Bumper Screw (64).
15
64
48
23
19
43
41
13
23
16. Press a 2Ó Square Inner Cap (17) into each end of
the Leg Lever (18). Press a 48mm Round Inner Cap
(12) into the end of the weight tube on the Leg Lever.
Lubricate an M10 x 75mm Bolt (8). Attach the Leg
Lever (18) to the bracket on the Front Leg (19) with
the Bolt and an M10 Nylon Locknut (11). Do not
overtighten the Nylon Locknut; it must be easy to
pivot the Leg Lever.
16
17
12
19
17
Lubricate
18
8
17
11