Filter
Top Products
12
17. Press a 3/4Ó Round Inner Cap (54) into each end of
the three Pad Tubes (38).
Press a Foam Pad (10) onto one end of a Pad Tube
(38). Insert the Pad Tube into one set of holes in the
bracket on the Front Leg (19). Press a Foam Pad
onto the other end of the Pad Tube.
Mount the other two Pad Tubes (38) in the indicated
holes in the Leg Lever (18) as described above.
17
18
38
54
38
54
54
10
54
10
10
10
19
18. Press a 30mm Square Inner Cap (32) into each end
of the Adjustment Tube (29).
Press a 1Ó Square Inner Cap (28) into each end of
the two Backrest Tubes (27). Attach the Backrest
Tubes to the Backrest (15) with four M6 x 38mm
Screws (4) and four M6 Washers (30). Note: Make
sure the indicated holes in the Backrest Tubes are
oriented as shown (on the wide end of the
Backrest).
18
28
30
15
28
29
4
30
32
30
4
32
27
19. Lubricate the M10 x 168mm Bolt (22). Attach the
Backrest (15) to the welded tube on the Bench Frame
(5) with the Bolt, two M10 Washers (6) and an M10
Nylon Locknut (11). Note: Do not overtighten the
Nylon Locknut; it must be easy to pivot the
Backrest.
19
6
6
Welded
Tube
11
15
5
22
20. Attach the Seat (14) to the brackets on the Bench
Frame (5) with four M6 x 16mm Screws (3). Make
sure that the wide end of the Seat is turned away
from the Backrest (15).
20
3
5
15
14
Holes
On This
End
Wide
End of
Seat