Filter
Top Products
8
12.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware
may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat
under the elliptical crosstrainer.
10.Slide the Left Upper Body Arm (15), which is marked
with an “L” sticker, onto the Chrome Tube (98) on the
Left Pedal Arm (not shown). Slide the Right Upper
Body Arm (18) onto the Chrome Tube on the Right
Pedal Arm (4). Make sure that the Upper Body Arms
are on the correct sides—the upper ends will bend
in the direction shown by the arrows. Next, slide an
Axle Cover (49) onto the post on each Upper Body
Arm.
Apply grease to the Arm Axle (34). Insert the Arm Axle
into the Upright (2), the right Pivot Cover (49), and the
Right Upper Body Arm (18) as shown. Push the Arm
Axle into the Upright until the left end of the Arm Axle is
flush with the left side of the Upright. Next, raise the
Left Upper Body Arm (15) and insert the Arm Axle into
the left Axle Cover (49) and the Left Upper Body Arm.
Center the Arm Axle.
10
11
2
49
49
Post
Post
Grease
34
34
51
80
80
101
105
101
104
15
15
18
11. Push an Axle Cap (51) onto the left Axle Cover (49).
Orient the Left Handlebar (104) as shown. Slide the
Left Handlebar onto the indicated post and the Arm
Axle (34). Attach the Left Handlebar with three M8 x
40mm Button Bolts (101) and three M8 Nylon Locknuts
(80).
Attach the Right Handlebar (105) in the same way.
98
98
4
9. While another person holds the Upright (2) near the
Frame (1), connect the Wire Harness (25) to the
Extension Harness (99). Attach the Upright to the
Frame with three M10 x 25mm Screws (100) and three
M10 Split Washers (13). Be careful to avoid pinching
the Wire Harnesses.
9
2
13
13
13
99
100
1
100
25
Make sure the
Wire Harnesses
(25, 99) do not
get pinched and
damaged during
this step.