Filter
Top Products
5
ASSEMBLY
Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been
pre-assembled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
M10 x 105mm Carriage Bolt (60)–2
3/4” Axle Cap (61)–2
57mm Spacer (22)–2
M10 Nylon
Locknut (26)–4
M8 x 19mm
Screw (30)–4
M8 Split
Washer (58)–4
M4 x 16mm
Screw (72)–1
M10 x 65mm Carriage Bolt (43)–2
M10 x 92mm Carriage Bolt (86)–2
M8 Nylon
Locknut (80)–8
M10 Split
Washer (13)–3
M10 x 25mm
Screw (100)–3
M8 Washer
(33)–6
M10 Washer
(94)–2
Plastic Pedal
Spacer (11)–2
M8 x 40mm Button
Bolt (101)–6
Console
Screw (35)–4