Filter
Top Products
79
97
84
55
9
4. Attach the Left Support (6) to the left Base (1)
with the indicated two M10 x 65mm Carriage
B
olts (83) and two M10 Nylon Locknuts (79). D
o
not tighten the Nylon Locknuts yet.
Attach an Upright Cap (34) to the Left Upright (3)
with two M4 x 16mm Screws (82).
Attach the Left Upright (3) to the Base (1) with the
indicated two M10 x 65mm Carriage Bolts (83)
and two M10 Nylon Locknuts (79). Do not tight-
en the Nylon Locknuts yet
.
See the inset drawing. Identify the Guide Rods
(5) and the Carriage Guides (64).
Attach a Guide Rod (5) to the Base (1) with an
M10 x 93mm Button Bolt (97), two M10 Washers
(84), two 25mm Spacers (55), and an M10 Nylon
Locknut (79).
Do not tighten the Nylon Locknut
yet.
Repeat this step with the Right Support (7),
the Right Upright (not shown), the other Guide
Rod (not shown), and the other Base (1).
5.
Orient the two Carriage Guides (64) with the rings
near the bottom. Attach the Carriage Guides to
the Center Base (2) with an M10 x 154mm Button
Bolt (99), two M10 W
ashers (84), two 6mm
Spacers (75), and an M10 Nylon Locknut (79).
Do not tighten the Nylon Locknut yet.
Slide two Guide Bumpers (27) onto the Carriage
Guides (64). Slide the Weight Carriage (41) onto
the Carriage Guides as shown.
82
82
3
5
6
7
34
4
1
1
84
83
55
79
79
83
79
5
99
84
84
79
2
75
27
41
64
64
27
5
64