Filter
Top Products
27. Identify the Low Cable (72). Route the Cable
through the Backrest Upright (8) and under a
1
10mm Pulley (59). Attach the Pulley inside the
Upright with an M10 x 93mm Button Bolt (97),
t
wo M10 Washers (84), two 25mm Spacers (55),
and an M10 Nylon Locknut (79).
2
7
97
8
4
55
7
2
55
59
84
79
8
16
29. Route the Low Cable (72) under a 90mm Pulley
(58). Attach the Pulley and two Half Finger
Guards (40) to the Center Base (2) with an M10 x
46mm Button Bolt (100) and an M10 Nylon
Locknut (79).
30. Wrap the Low Cable (72) over a 90mm Pulley
(58).
Attach the Pulley, a Small Cable Trap (63),
and two Half Finger Guards (40) to the second
hole from the bottom of the two Pulley Plates (74)
with an M10 x 53mm Button Bolt (147) and an
M10 Nylon Locknut (79).
Make sure that the
Cable T
rap is oriented to hold the Cable in the
groove of the Pulley.
79
72
58
2
40
40
100
29
28. Route the Low Cable (72) over a 90mm Pulley
(58). Attach the Pulley and two Half Finger
Guards (40) to the Double “U”-bracket (46) with
an M10 x 46mm Button Bolt (100) and an M10
Nylon Locknut (79).
28
46
40
40
79
100
72
58
30
40
40
58
72
74
74
63
147
79