Filter
Top Products
14
19. Route the Butterfly Cable (71) over a “V”-pulley
(60). Attach the “V”-pulley, a Large Cable Trap
(
61), an M10 Washer (84), and two Full Finger
Guards (39) to the Backrest Upright (8) with an
M
10 x 62mm Button Bolt (88) and an M10 Nylon
Locknut (79). Make sure that the Large Cable
Trap is oriented to hold the Cable in the
groove of the “V”-pulley.
21. Locate the High Cable (73). Route the Cable up
through the Top Frame (16) and over a 90mm
Pulley (58). Attach the Pulley inside of the Top
Frame with an M10 x 93mm Button Bolt (97), two
M10 Washers (84), two 25mm Spacers (55), and
an M10 Nylon Locknut (79).
22.
Route the High Cable (73) over a 90mm Pulley
(58) and down through the
T
op Frame (16).
Attach the Pulley inside the Top Frame with an
M10 x 93mm Button Bolt (97), two M10 Washers
(84), two 25mm Spacers (55), and an M10 Nylon
Locknut (79).
20. Attach the Butterfly Cable (71) to the Left Arm
(10) with an M8 x 19mm Shoulder Bolt (85) and
an M8 Nylon Locknut (78). Do not overtighten
the Nylon Locknut; the Cable must pivot easi-
ly.
85
78
71
10
58
55
55
84
97
79
16
73
21
84
3
9
3
9
60
71
79
61
8
88
84
19
22
73
58
55
84
55
84
79
16
97
20