Filter
Top Products
13
16. The following steps are shown from the rear
of the weight rack. See the CABLE DIAGRAMS
on pages 29 and 30 to identify cables as you
assemble them.
Identify the Butterfly Cable (71).
Attach the
Cable to the Right Arm (11) with an M8 x 19mm
Shoulder Bolt (85) and an M8 Nylon Locknut (78).
Do not overtighten the Nylon Locknut; the
Cable must pivot easily.
15. Attach the Foot Plate (9) to the Center Base (2)
and the Backrest Upright (8) with four M10 x
1
9mm Button Bolts (77) and four M10 Nylon
Locknuts (79).
See steps 2–12. Tighten all of the bolts,
screws, and nylon locknuts.
See steps 14–15. Tighten all of the bolts,
screws, and nylon locknuts.
17. Route the Butterfly Cable (71) over a “V”-pulley
(60). Attach the “V”-pulley, a Large Cable Trap
(61), an M10 Washer (84), and two Full Finger
Guards (39) to the Backrest Upright (8) with an
M10 x 62mm Button Bolt (88) and an M10 Nylon
Locknut (79).
Make sure that the Large Cable
Trap is oriented to hold the Cable in the
groove of the “V”-pulley.
85
16
71
11
78
17
88
61
60
84
79
8
39
71
39
15
77
79
79
9
2
8
77
18. Route the Butterfly Cable (71) under a 90mm
Pulley (58). Attach the Pulley and two Half Finger
Guards (40) to the Double “U”-bracket (46) with
an M10 x 46mm Button Bolt (100) and an M10
Nylon Locknut (79).
100
46
71
58
40
79
18