Filter
Top Products
18
ASSEMBLY GUIDE
ASSEMBLY PROCESS
Step 4: Installing Upright Covers
Locate the following for this step:
Parts:
• Assembly from Step 3
• Right Lower Upright Plastic Cover (Qty. 1) -
• Left Lower Upright Plastic Cover (Qty. 1)
Hardware:
• #8 Phillips Head Screw (Qty. 8)
Tools:
• Phillips Screw Driver
4-1 Unlock treadles.
4-2 Raise the right treadle to full height allowing for
access to the inside of the right upright support.
4-3 Align the Right Lower Plastic Cover to the Right
Upright Support by sliding the bosses into the
upright. Attach the Right Lower Upright Plastic
Cover to the Right Upright Support using two of
the #8 Phillips head screws from the inside of the
support.
4-4 Repeat process on left side.
Figure 4: Installing Upright Covers
Phillips Head Screws
Lower Upright Plastic Cover
Phillips Head Screws
Lower Upright
Plastic Cover