ZyXEL Communications P-2812HNU-51c Manual

A SERVICE OF

next previous

Chapter 1 Introducing the P-2812HNU-51c

P-2812HNU-51c User’s Guide

29

Note: You must activate WPS in the P-2812HNU-51c and in another wireless device

within two minutes of each other. See Section 7.11.4 on page 175 for more

information.

1.5 The RESET Button

If you forget your password or cannot access the web configurator, you will need

to use the RESET button at the back of the device to reload the factory-default

configuration file. This means that you will lose all configurations that you had

previously and the password will be reset to “1234”.

1.5.1 Using the Reset Button

1 Make sure the POWER LED is on (not blinking).

2 To set the device back to the factory default settings, press the RESET button for

ten seconds or until the POWER LED begins to blink and then release it. When the

POWER LED begins to blink, the defaults have been restored and the device

restarts.