Chapter 45 Introducing Commands
ES-4124 User’s Guide
376
egress Enables bandwidth limits allowed
for outgoing traffic on the port(s).
13
egress <Kbps> Sets the maximum bandwidth
allowed for outgoing traffic on the
port(s).
13
bpdu-control
<peer|tunnel|disc
ard|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
13
broadcast-limit Enables broadcast storm control
limit on the Switch.
13
<pkt/s> Specifies the maximum number
of broadcast packets allowed to
pass through this port per
second. Broadcast packets
above this threshold are dropped
by the Switch.
13
dhcp snooping
trust
Sets this port as a trusted DHCP
snooping port. Trusted ports are
connected to DHCP servers or
other switches, and the Switch
discards DHCP packets from
trusted ports only if the rate at
which DHCP packets arrive is too
high.
13
dhcp snooping
limit rate <pps>
Sets the maximum rate that
DHCP packets are allowed to
arrive at a trusted DHCP
snooping port.
13
diffserv Enables DiffServ on the port(s). 13
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
13
<pkt/s> Sets the interface DLF limit in
packets per second (pps).
13
egress set <port-
list>
Sets the outgoing traffic port list
for a port-based VLAN.
13
ethernet oam Enables Ethernet OAM on the
port(s).
13
mode
<active|passive>
Specifies active or passive OAM
mode on the ports. Active mode
allows the port to issue remote
loopback and discovery
commands. Passive mode
means that the port can only
respond to Ethernet OAM
commands.
13
remote-loopback
supported
Enable Ethernet OAM remote-
loopback capability on the
port(s).
13
exit Exits from the interface port-
channel command mode.
13
Table 142 interface port-channel Commands (continued)
COMMAND DESCRIPTION PRIVILEGE
