Managing Device Security
366
ProSafe M5300 Switch
To configure TACACS+ server settings:
1. Use TACACS+ Server to enter the configured TACACS+ server IP address.
2. Use Priority to specify the order in which the TACACS+ servers are used. It should be
within the range 0-65535.
3. Use Port to specify the authentication port. It should be within the range 0-65535.
4. Use Key String to specify the authentication and encryption key for TACACS+
communications between the device and the TACACS+ server. The valid range is 0-128
characters. The key must match the encryption used on the TACACS+ server.
5. Use Connection Timeout to specify the amount of time that passes before the connection
between the device and the TACACS+ server time out. The range is between 1-30.
6. Click ADD to add a new server to the switch. This button is only available to READWRITE
users. These changes will not be retained across a power cycle unless a save is performed.
7. Click DELETE to delete the selected server from the configuration.
Authentication List Configuration
The Authentication List folder contains links to the following features:
• Login Authentication List on page 366
• Enable Authentication List on page 367
• Dot1x Authentication List on page 369
• HTTP Authentication List on page 369
• HTTPS Authentication List on page 370
Login Authentication List
You use this page to configure login lists. A login list specifies the authentication method(s)
you want to be used to validate switch or port access for the users associated with the list.
The pre-configured users, admin and guest, are assigned to a pre-configured list named
defaultList, which you may not delete. All newly created users are also assigned to the
defaultList until you specifically assign them to a different list
To display the Login Authentication List page, click Security
Management Security >
Authentication List
Login Authentication List.
