4-95
Maintaining and Transporting the Printer | 95
Viewing Status Information
To view printer status information instead of printing it, follow these steps:
1. Press the
Menu button. You see PRINTER SETUP.
2. Press the button until you see
PRINTER STATUS, then press
Menu . You see VERSION.
3. Do one of the following:
• To check the firmware version, press Menu again. When done,
press the button.
• To check the amount of ink left, press until you see INK LEFT,
then press
Menu . The status of the first cartridge (MK, or matte
black) is displayed, using the
E*****F symbols described above.
Continue pressing to see the status of the remaining cartridges.
When done, press the button.
• To check how much of the maintenance tank has been used, presss
until you see
MAINT TANK, then press Menu . The status of
the tank is displayed, using the
E*****F symbols described above.
When done, press the button.
• To check the amount of ink used (in milliliters) and paper used
(in square meters), press until you see
USAGE COUNT, then
press
Menu .
You can change the units of measurement from meters to inches
and feet by using the maintenance mode on the printer’s control
panel. See page 105 for instructions.
• To check job history, press until you see JOB HISTORY, then
press
Menu . For each job saved in the printer, you see the ink
used (in milliliters) and paper used (in square meters). The most
recent job is saved as No. 0. When done, press the button.
• To check the total number of prints, press until you see TOTAL
PRINTS
, then press Menu . When done, press the button.
sp4000Guide.book Page 95 Friday, October 22, 2004 5:06 PM
