Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
6.1.1.0 Introduced on the E-Series.
Usage
Information
When you use the log option, the CP processor logs details about the packets that
match. Depending on how many packets match the log entry and at what rate, the
CP may become busy as it has to log these packets’ details.
NOTE: When you configure the ACL logging and byte counters
simultaneously, byte counters may display an incorrect value. Configure
packet counters with logging instead.
Related
Commands
deny — configures a MAC ACL filter to drop packets.
seq — configure a MAC ACL filter with a specified sequence number.
IP Prefix List Commands
When you create an access-list without any rule and then apply it to an interface, the ACL behavior
reflects implicit permit.
To configure or enable IP prefix lists, use these commands.
clear ip prefix-list
Reset the number of times traffic mets the conditions (“hit” counters) of the configured prefix lists.
Syntax
clear ip prefix-list [prefix-name]
Parameters
prefix-name (OPTIONAL) Enter the name of the configured prefix list to
clear only counters for that prefix list, up to 140 characters
long.
Defaults Clears “hit” counters for all prefix lists unless a prefix list is specified.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Access Control Lists (ACL)
237
