31 | P a g e © Adam Equipment Company 2011
The next line shows: “LINE NO 2” “TIME” - prints time
Only one item can be entered per line.
Continue until the formatting of the form is complete. There are 15 lines of
possible data. After the 15th line has been set or “END” has been selected, the
balance will return to the RS-232 Sub-menu.
Press [Mode] to advance to setting of the next menu or press [Esc] to return to
normal weighing.
12.4 SETUP PARAMETERS
The user parameters that control the balance are shown under the SETUP. When
“SETUP” is displayed, press the [Setup/Enter] key. The options for each
parameter can be scrolled through by using the [Up] or [Down] key.
TIME Set Time using the numeric entry method (see
section 5.1)
DATE DATE FORM
EUROPE (dd/mm/yy)
USA (mm/dd/yy)
ASIA (yy/mm/dd)
Set Date using the numeric entry method (see
section 5.1)
USER ID Enter a user number to identify the user or the
balance
BUZZER On= Enable OFF= Disable
BACKLIGHT On OFF AUTO
POWER DOWN
Set the time after which the unit will go into
Stand-by power settings, On=Enable, OFF=Disable,
If set to On-the options are 1 to 9 minutes
FILTER
Set a value for the amount of filtering to be done,
set to normal, slow or fast.
STABILITY
Set a value to be used to determine balance
stability, set a value of 1, 2, 5 or 10d. A larger
number corresponds to a larger stable zone.
AUTO ZERO Can be set to On or OFF to enable the auto-zero
function. If set to On- select from 1, 2 or 5d
The sub-menu is entered by pressing [Enter] –
