30 | P a g e © Adam Equipment Company 2011
Format of custom forms #1 and #2
If FORM1 or FORM2 is selected, it can be changed by the user using a selection of
available data. By default the 2 forms are the same as the standard form unless
changed by the user as below.
When FORM 1 or FORM 2 is selected the user can set the information to be printed
on each line of the form. Pressing the [Up] or [Down] keys will cycle through the
options available. The options are:
INST ID Instrument ID number
SER No Serial Number
TIME Time
DATE Date
NET Net Weight (Gross weight – Tare Weight)
GROSS Gross Weight
TARE Tare Weight
UNIT Unit weight in parts counting mode
COUNT Number of items in parts counting mode
REF 100% weight in percent weighing mode
PERCENT Percentage of reference weight in percent weighing
LO LIMIT Low Limit when check weighing
HI LIM High Limit when check weighing
Cr Lf Inserts a blank line
END Signifies the end of the report
When END is entered the display returns to the RS-232 Sub-menu
Enter the data to be printed on the first line by pressing the [Up] or [Down] key
to cycle through the options. If the current information is OK then press the
[Setup/Enter] key to move to the next line.
e.g. “LINE No1” “DATE” - prints date
Select a code for one of the preset data formats as detailed above.
