29 | P a g e © Adam Equipment Company 2011
12.2 ENABLE WEIGHING MODES
Same steps are followed to enable or disable the weighing modes.
1) Press [Enter] when “MODES” is displayed. The display will show the first mode
i.e., Parts Counting (“PARTS”) together with its enabled state “OFF” or “On”.
The user can enable or disable the parts counting mode by using [Up] or
[Down]. Pressing [Enter] will confirm the setting and will advance to the next
weighing mode. Repeat for each mode in turn
2) Press [Mode] to advance to setting of the next menu or press [Esc] to return
to normal weighing
12.3 ENABLE SERIAL INTERFACE PARAMETERS
The parameters affecting the serial setup are set in a similar manner to the other
parameters.
Press [Enter] when “SERIAL” is displayed to enter the sub-menu.
The parameters that can be set are:
ENABLE The serial port can be set to On or OFF
BAUD RATE Set the Baud Rate to 4800, 9600, 19200 or 38400
PARITY Set the Parity to NONE, EVEN or ODD
8 data bits and one stop bit are always used, (8n1, 8E1, 8o1).
STABLE To print when stable (On) or regardless of stability (OFF)
CONTINUOUS Set the RS-232 to send data continuously to On or OFF
PERIODIC Set the RS-232 to send data periodically (set in seconds) to On or OFF. If
On is selected, the value can be changed between 1 and 999 seconds,
using [Up] and [Down]
FORMAT
To send data as a single line of data, using the standard format or using a
customer designed format (FORM 1 or FORM 2).
During continuous or periodic printing only the weight is printed. Forms
are not available.
