11 | P a g e © Adam Equipment Company 2011
6.2 PASSCODES
If a passcode has been set to limit access to the weighing functions of the balance
the display will show “PASSCODES” with the main digit set to zero. The display will
change to show 7 digits set to zero with the rightmost digit flashing. Use the numeric
entry method (see section 5.1) to enter the code. Make sure to enter the correct
passcode to continue. See the Section 12.6 for details.
6.3 WEIGHING
1) Press [→
→→
→0/T←
←←
←] to zero the balance, if required, “→0←” will be displayed
2) Place a mass on the pan and the weight will be displayed
3) If a container is used press [→
→→
→0/T←
←←
←] to tare the balance (zero the display)
when the stable symbol “~” is on. “Net” will be displayed to indicate that the
balance is tared
4) When the display shows zero, place the item to be weighed. Only the net
weight will be displayed. The capacity tracker at the bottom of the LCD will
indicate the weight graphically with respect to the maximum weighing
capacity
5) At any time the [Unit] key can be pressed to select another unit. Use the [Up]
or [Down] key to scroll through the units and select the desired unit by
pressing the [Enter] key, the display will change to show the weight in the
selected weighing unit. The available weighing units can be enabled or
disabled by the user (see section 12.1). Only weighing units that have been
enabled will be cycled through when the [Unit] key is pressed
