Adam Equipment PGL Series Manual

A SERVICE OF

next previous

10 | P a g e © Adam Equipment Company 2011

6.0 BASIC

OPERATION

6.1 INITIALISATION

1) When the balance is first switched on, it will display the balance serial number

(if set), software revision, model capacity and then all segments on the display

will be shown. Overall the time taken is usually 5 -10 seconds.

2) If a passcode has been set, the display will show “PASSCODE” and the main

display will show a zero. In this case you must enter the passcode to continue

using the numeric entry method (see section 5.1). A different passcode may

be set for a Supervisor to weigh or to have access to the selected User menus.

If the passcode has not been set the balance will continue as below.

3) The display will show zero reading along with the zero symbol “→0←” and

the weighing unit last used. If automatic time calibration is enabled the

balance will calibrate after power up and again after the pre-set time interval.