Weslo WLTL46080 Home Gym User Manual


 
9
6. Lay the Lat Cable (40) over a Pulley (42). Slide the
Cable Trap (47) and Pulley onto a 3/8” x 1 1/2”
Pulley Bolt (46). Next, insert a Square Nut (30) into
the bracket on the Lat Tower (34) and insert a
screwdriver up into the bracket to hold the Square
Nut in place. Insert the 3/8” x 1 1/2” Pulley Bolt (46)
into the bracket and tighten it into the Square Nut.
Make sure that the Cable Trap (47) is turned to
the position shown, and that the Pulley (42)
turns freely.
7. Lay the Lat Cable (40) over another Pulley (42).
Attach the Pulley to the Lat Tower (34) with a 3/8” x
4 1/2” Pulley Bolt (44), a 3/8” Washer (31), a Pulley
Spacer (48), and a 3/8” Jam Nut (11).
Make sure that the Lat Cable (40) is between the
Pulley (42) and the welded pin, and that the
Pulley turns freely.
7
34
44
31
42
48
40
Pin
11
6
40
42
30
Bracket
34
46
47
8. Press a Stabilizer Cap (81) onto each end of the
Bench Stabilizer (21).
Attach the Bench Stabilizer (21) to the Bench Frame
(5) with two 1/2” x 2” Carriage Bolts (22) and two
5/16” Nylon Locknuts (15).
9. Attach the Weight Tube (17) to the Leg Lever (14)
with a 5/16” x 2” Bolt (19) and a 5/16” Nylon Locknut
(15).
Press a 1” Inner Cap (16) into the indicated end of
the Weight Tube (17). Press the 1” Outer Cap (18)
onto the other end of the Weight Tube. Slide the
Weight Bushing (74) onto the Weight Tube.
Press a Frame Cap (7) into each end of the Leg
Lever (14).
9
81
81
21
15
5
22
74
16
17
15
19
18
14
7
7
8