Filter
Top Products
10
11. Tap two 3/4” Inner Caps (12) into each Pad Tube
(20).
Insert the Pad Tubes (20) through the holes in the
Leg Lever (14). Center the Pad Tubes and slide two
Foam Pads (12) onto each Pad Tube.
10. Lubricate the 3/8” x 2 1/4” Bolt (10). Attach the Leg
Lever (14) to the Bench Frame (5) with the Bolt and
a 3/8” Jam Nut (11). Do not overtighten the Jam
Nut. The Leg Lever must pivot freely.
10
14
5
10
11
11
14
13
12
20
13
12
12. Attach a Backrest Bracket (2) to the Backrest (1)
with two 1/4” x 3/4” Screws (3). Make sure that the
Backrest Bracket is oriented as shown. Do not
tighten the Screws yet.
13. Refer to drawing 13a. Hold the Backrest (1) in a
vertical position as shown and slide the end of the
attached Backrest Bracket (2) onto the welded rod
on the Bench Frame (5). Hold the other Backrest
Bracket (2) at an angle as shown and slide it onto
the rod.
Refer to drawing 13b. Attach the Backrest Bracket
(2) to the Backrest (1) with two 1/4” x 3/4” Screws
(3). Note: The Screw nearest the rod should be
attached first.
Fully tighten all four 1/4” x 3/4” Screws (3) used
in steps 12 and 13.
13a
1
12
1
3
3
2
1
3
2
5
Rod
Rod
3
2
2
13b