Weslo WLTL46080 Home Gym User Manual


 
8
3. You have one of two types of Carriage Pins (38). If
you have type 2 (refer to the drawing), make sure
the Carriage Pin Knob (39) is attached to the
Carriage Pin (38).
Slide the Weight Carriage (23) onto the Lat Tower
(34). Make sure that the Weight Carriage is
turned as shown in the inset drawing. Slide the
Weight Carriage to the position shown and insert
the Carriage Pin (38) through the Weight Carriage
and the Lat Tower.
4. Hold the Lat Tower (34) in the position shown. Make
sure that the Lat Tower is turned as shown on page 5.
Attach the Base Plate (27) and the Corner Base
(33) to the Lat Tower (34) with two 3/8” x 3 1/4”
Bolts (32), two 3/8” Washers (31), and two 3/8” Jam
Nuts (11).
Lay the Lat Tower (34) down on the floor so that
it cannot be tipped over. The assembly of the
Lat Tower will be completed in step 17.
38
Type 2
Type 1
39
34
23
3
4
11
27
33
34
32
31
31
5. Identify the indicated end of the Lat Cable (40).
Attach the Lat Cable to the tab on the Weight
Carriage (23) with a 3/8” x 1” Lat Bolt (141), a 3/8”
Washer (31), and a 3/8” Jam Nut (11). Note: Do
not fully tighten the Jam Nut.
5
141
31
40
11
Tab
23
Weight Tube
must angle upward