Filter
Top Products
7
Assembly
Everything in this manual is designed to ensure
that the CADENCE DL35 can be assembled suc-
cessfully by anyone. However, it is important to
recognize that the CADENCE DL35 contains
many parts and that the assembly process will
take time. Most people find that by setting aside
plenty of time and by deciding to make the task
enjoyable, assembly will go more smoothly.
Before beginning, make sure that you under-
stand the following important points:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• For help identifying small parts, refer to the Part
Identification Chart on page 6.
• During assembly, make sure that all parts are ori-
ented as shown in the drawings.
The following tools (not included) are required
for assembly:
• Two (2) adjustable wrenches
• One (1) rubber mallet
• One (1) standard screwdriver
• One (1) phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
1. With the help of a second person, raise the Uprights
(70) to the position shown in drawing 1. Next, pivot
the Console (51) to the position shown in drawings
1 and 1a. Tighten the two Console Bolts (56).
The Console (51) requires two “AA” batteries (not
included). Alkaline batteries are recommended.
Refer to drawing 1b. Slide the Battery Cover (52)
upward and remove it. Insert two “AA” batteries into
the Console (51), making sure that the negative
ends of the batteries (marked “–”) are touching the
springs in the Console. Reattach the Battery Cover.
2. Attach the the Catch (124) to the left side of the
Frame (123) with four Catch Screws (126). Make
sure that the Catch is turned as shown. Note: It
may be necessary to remove the Catch Screws
from the left side of the Frame before beginning this
step.
1
1a
1b
70
51
51
51
126
124
123
56
52
2