Weslo WLTL46080 Home Gym User Manual


 
12
17. Insert the left end of the Bench Pivot Rod (8) into
the indicated hole in the Lat Tower (34). Loosely
thread a Bench Pivot Bolt (41) with a 5/16” Washer
(102) into the end of the Bench Pivot Rod.
Next, insert the right end of the Bench Pivot Rod (8)
into the Upright (70) and slide the Corner Base (33)
against the lower end of the Upright. Loosely thread
a Bench Pivot Bolt (41) with a 5/16” Washer (102)
into the end of the Bench Pivot Rod.
Loosely attach the Corner Base (33) to the Upright
(70) with two 3/8” x 3 1/4” Bolts (32), two 3/8”
Washers (31), and two 3/8” Jam Nuts (11).
20. Make sure that all parts are properly tightened before you use the CADENCE DL35. If desired, attach
the included allen wrench to the treadmill frame with the plastic adhesive clip.
17
34
32
31
31
11
33
8
102
41
102
70
41
19. Make sure that there are Handgrips (35) on the
ends of the Lat Bar (36).
Attach the Lat Bar (36) to the Lat Cable (40) with a
Cable Clip (37).
19
36
37
40
35
35
18. Raise the Bench Frame (5) to the position shown
and hold it in place. Insert the Support Rod (25)
through the indicated holes in the Lat Tower (34),
the Bench Frame (5), and the Upright (70). Rotate
the Support Rod to the locked position, with the
hook clipped onto the Lat Tower as shown in the
inset drawing.
Refer to step 17. Tighten all parts assembled in
step 17.
18
5
34
25
70
Hook