8
5. Have a second person lift and hold the front end
of the Frame (61). Hold an Upright Spacer (88)
between the Right Upright (87) and the Frame.
Attach the Right Upright to the Frame with an
M10 x 110mm Bolt (1), an M10 Washer (12), and
an M10 Star Washer (11). Do not tighten the
Bolt yet.
Repeat this step on the left side of the tread-
mill.
5
61
1
87
88
12
11
4. With the help of a second person, raise the
Uprights (86, 87) so the Base (91) is flat on the
floor as shown. Next, position the front of the
F
rame (61) between the Uprights.
S
ee the inset drawing. Locate the wire tie in-
side of the lower end of the Right Upright (87).
Secure the wire tie to the Wire Harness (83).
Then, pull the upper end of the wire tie until the
end of the Wire Harness is extending from the
upper end of the Right Upright.
4
91
87
61
86
83
8
3
87
Wire
T
ie