Filter
Top Products
10
8. Attach the Right Handrail (82) to the Console
(94) with an M5 x 16mm Screw (9), an M5 Star
Washer (13), and two M4.2 x 19mm Screws (5).
M
ake sure that no wires are pinched. Start all
three Screws before tightening any of them.
T
ighten the M5 x 16mm Screw and then
tighten the M4.2 x 19mm Screws. Do not
overtighten the Screws.
Attach the Left Handrail (79) to the other side
of the Console (94) in the same way. Note:
There are no wires on the left side of the
Console.
Remove the plastic ties from the Right Handrail
(82) and the Left Handrail (79). If necessary,
press the M8 Cage Nuts (41) into place.
8
9
9
5
94
82
79
13
13
5
5
5
83
9
9. Have a second person hold the Console (94)
near the Right Upright (87) and the Left Upright
(not shown).
Connect the Wire Harness (83) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Remove the wire tie from the
Wire Harness. Insert the connectors and excess
wire into the Right Upright (87).
Next, insert the brackets on the Right Handrail
(82) and the Left Handrail (not shown) into the
Right Upright (87) and the Left Upright (not
shown). Make sure that no wires are pinched.
87
83
Console
Wire
94
41
41
Wire
Tie
Console
Wire
82