Filter
Top Products
g.
Attach two 8mm Metal Spacers (97), a 60mm
Metal Spacer (39), and two Bearing Wheels (46)
to one end ofthe Seat Carriage (12) with an M8 x
104mm Bolt(60) and an M8 Nylon Locknut (65)
as shown. Be sure the parts are oriented as
shown in the inset drawing; the Seat Knob
(not shown) will not engage the Bench Rail
(not shown) if they are incorrectly oriented.
Do not overtighten the Locknut; the Bearing
Wheels must be able to roll easily.
Attach two Bearing Wheels (not shown) to the
other end of the Seat Carriage (12) in the
same manner.
10. Attachthe Seat Knob (45) tothe Seat Carriage
(12) with two M6 x 13mm Bolts(92) and two M6
Nylon Locknuts(69). Be sure that the slot in the
Knob is aligned with the slot in the Seat
Carriage, as shown.
Orient the Seat (13), the Seat Backing(9), and
the Seat Carriage (12) as shown.Attach the Seat
and the Seat Backingto the Seat Carriage with
four M6 x 16mm Bolts(82).
11. Pullout the Seat Knob (45) as far as itwill go,and
set the Seat Carriage (12) on the Bench Rail (5).
Looselyattach two8mm Metal Spacers (97), a
60mm Metal Spacer (39), and two Bearing
Wheels (46) to the center holes in the Seat
Carriage (12) with two M8 Flange Nuts (19) and
the M8 x 114mm Bolt(57). Make sure that the
serrated edge of the Flange Nuts are against
the Seat Carriage.
While a second person presses downon the Seat
(13), hold the wheel assembly firmlyagainstthe
bottomof the Bench Rail (5) and propedy tighten
the M8 Flange Nuts (19). Make sure that three
threads are extending past the Nut, and that
the wide sides of all six Wheels (46) are
pressed against the Bench Rail.
Engage the Seat Knob (45) intoan adjustment
hole inthe Bench Rail (5).
9
10
12
6L _Attach second
_-._ ./_. ,// set of wheels
_ here
• i ,L_'-65
97 -"_€'_ _.
/_1 46
Slots
11 19 13 ///
ustmentHole
97
_/(_ ._6 97
8