Filter
Top Products
24.LocatetheLegLeverCable(32),whichhastwo
endsthatarethesamelengthandathirdend
thatislonger.
RoutethelongestendoftheLegLeverCable
(32)throughtheholeintheFrontLeg(6),and
attachit insideoftheholeintheLegLever(7)
withanM10x 6OmmBolt(63)and an M10 Nylon
Locknut(76).
25. Attach a 90mm Pulley(28) inside ofthe holein
the Front Leg (6) with an M10 x 91ram Bolt(90),
two 26mm Spacers (52), two M10 Washers (75),
end an MI0 Nylon Locknut (76). Be sure the
Pulley is above the Leg Lever Cable (32).
Slide the twofree ends of the Leg Lever Cable
(32) onto the hookwelded to the bottomof the
Bench Rail (5).
26. Locate the two Short Cables (33). Wrap one of
the Cables around a 90mm Pulley(28). Attach
the Pulleyto a High Pulley Housing(21) with an
M10 x 42mm Button Head Boit(71) and an M10
Nylon Locknut(76).
Repeat this step with the other Short Cable
(33).
27. Slidethe four Foam Pads (26) onto the tubes on
the Front Leg (6) and the Leg Lever (7). Press
four 19ram Round inner Caps (78) into the ends
of the tubes.
24
25
6
9O
26
-75
76
76
Hook
21
71
27 26
26
7
26
28. Make sure that all parts have been propedy tightened. The use of the remaining parts will be explainedin
ADJUSTMENTS, beginning on the followingpage,
Beforeusingthe resistancesystem, pull the long cable a few timesto be sure that itmoves smoothlyover
the pulleys.If the cable does not move smoothly,findand correctthe problem. IMPORTANT: If the cables
are not properly installed, they may be damaged when heavy resistance is used. See the CABLE
DIAGRAM on page t6 for proper cable routing.
12