Filter
Top Products
9
9. Attach a Roller (39) between the indicated set of
holes in the Squat Slider (38) with an M8 x 85mm
Bolt (94) and an M8 Nylon Locknut (86) as shown.
Do not overtighten the Locknut.
Assemble the other three Rollers (39) to the
Squat Slider (38) in the same manner.
10. Slide the Squat Slider (38) down onto the Squat
Upright (4).
11. Orient the Weight Guides (42) with the indicated
holes on top. Insert the ends of two Weight Guides
into the indicated bracket on the Long Base (106).
Slide two Weight Bumpers (49) onto the Weight
Guides. Next, slide ten Weights (44) onto the Weight
Guides. Make sure that the Weights are turned so
the grooved sides of the Weights are facing
downward.
Press a Weight Tube Bumper (48) into the lower
end of a Weight Tube (43). Insert the Weight Tube
into the centers of the W
eights (44). Make sure
that the Weight Tube is turned as shown.
Lubricate the two outer holes in a
T
op Weight (45).
Slide the Top Weight onto the Weight Guides (42).
Make sure that the Top Weight is turned so the
grooved side is facing downward.
Apply a number “10” decal to the Top Weight (45) in
the location shown. Apply decals with the numbers
20 through 110 to the ten Weights (44).
Assemble the other weight stack in the same
way
.
9
10
49
106
Groove
Lubricate
Holes
43
48
42
42
45
44
“10” Decal
“110” Decal
Holes
11
38
4
39
39
39
94
86
38
“20” Decal