Filter
Top Products
18
49. Wrap the Swivel Low Cable (72) over a 90mm
Pulley (78).
Attach the Pulley and a Cable Trap (68)
between the lower set of holes in the “U”-bracket
(64) with an M10 x 50mm Bolt (100) and an M10
Nylon Locknut (87).
Make sure that the Cable
Trap is turned to hold the Cable in the groove of
the Pulley.
51. Locate the Squat Cable (73), which is the only
remaining cable. Attach the eyelet end of the
Cable inside of the Long Base (106) with an M10 x
65mm Bolt (59), two M10 Washers (91), and an
M10 Nylon Locknut (87).
50. Attach the end of the Swivel Low Cable (72) inside
of the Short Base (2) with an M10 x 65mm Bolt
(59), two M10 Washers (91), and an M10 Nylon
Locknut (87).
52.
Wrap the Squat Cable (73) over a 90mm Pulley
(78). Attach the Pulley, a Cable Trap (68), and two
19mm Spacers (101) between the indicated brack
-
ets on the Squat Slider (38) with an M10 x 85mm
Bolt (96) and an M10 Nylon Locknut (87). Make
sure that the Cable T
rap is turned to hold the
Cable in the groove of the Pulley.
49
50
51
52
59
91
2
87
38
68
72
100
64
87
101
87
59
91
73
91
87
106
72
96
73
78
101
91
78
68