Weider 831.153932 Home Gym User Manual


 
10
14. Open the parts bag labeled “ARM ASSEMBLY.”
Press three 40mm x 50mm Inner Caps (21) into the
Leg Lever (10). Attach the Eyebolt (116) to the Leg
Lever with an M10 Washer (91) and an M10 Nylon
Locknut (87).
Lubricate an M10 x 65mm Bolt (59) with grease.
T
urn the Leg Lever (10) so that the welded tab is
on the indicated side, and attach the Leg Lever to
the Seat Upright (9) with the Bolt and an M10 Nylon
Locknut (87).
Do not overtighten the Locknut;
the Leg Lever must be able to pivot easily
.
15. Press a 50mm x 70mm Inner Cap (34) into the
Butterfly Frame (47).
Attach the tethers on the two
“L”-pins w/Tether (60) to the Butterfly Frame with an
M4 x 20mm Self-tapping Screw (14).
Lubricate a an M10 x 75mm Bolt (107) with grease.
Attach the Butterfly Frame (47) to the Butterfly Top
Frame (7) with the Bolt and an M10 Nylon Locknut
(87).
Do not overtighten the Locknut; the
Butterfly Frame must be able to pivot easily.
ARM ASSEMBLY
13. Press two 50mm x 75mm Inner Caps (58) into the
Top Frame (6) and the Butterfly Top Frame (7).
Attach the Butterfly Top Frame (7) to the Top Frame
(6) with two M10 x 70mm Bolts (85), two M10
Washers (91), and two M10 Nylon Locknuts (87).
Do not tighten the Locknuts yet.
Attach the Butterfly Top Frame (7) to the Butterfly
Upright (3) with two M10 x 95mm Bolts (92), two
M10 Washers (91), and two M10 Nylon Locknuts
(87).
Tighten all of the M10 Nylon Locknuts (87) used
in steps 2–13.
12
13
14
21
21
116
91
87
21
10
87
59
Lubricate
9
Tab
15
34
87
107—Lubricate
47
60
14
7
60
6
87
87
91
91
87
4
5
95
95
87
42
91
91
52
92
52
92
7
87
85
91
91
6
87
3
58
92
91
58
12. Attach the Top Frame (6) between the Squat Upright
(4) and the Swivel Upright (5) with four M10 x 95mm
Bolts (92), the two Short Frame Plates (52), and two
M10 Nylon Locknuts (87) as shown.
Do not tighten
the Bolts and Locknuts yet.
Attach the four Weight Guides (42) to the Top Frame
(6) with two M10 x 165mm Bolts (95), four M10
Washers (91), and two M10 Nylon Locknuts (87).