Filter
Top Products
20
57. Attach the Seat (16) to the Seat Frame (8) with two
M6 x 16mm Screws (114), an M6 x 65mm Screw
(99), and an M6 W
asher (97).
58. Attach the Butterfly Backrest (15) to the Butterfly
Upright (3) with four M6 x 16mm Screws (114).
59. Wet one end of the Squat Arm (32) and inside of a
Short Pad (20) with soapy water. Slide the Pad (20)
onto the Squat Arm as shown.
Attach the Squat Handle (33) to the Squat Arm (32)
with two M8 x 20mm Button Head Screws (51).
Slide a 50mm Outer Cap w/Hole (111) onto the
Squat Handle and press it onto the end of the
Squat Arm. Slide the Short Pad (20) over the
Screws.
W
et the Squat Handle with soapy water
. Slide an
200mm Handgrip (84) onto the Squat Handle.
Repeat this step with the other end of the Squat
Arm (32).
57
58
59
51
51
20
20
32
33
111
84
97
114
114
99
114
16
8
15
3
60
60.
Attach the Squat
Arm (32) to the Squat Bracket (37)
with two M10 x 65mm Carriage Bolts (110) and two
M10 Nylon Locknuts (87).
Do not tighten the
Nylon Locknuts yet.
Finish attaching the Squat Arm (32) to the Squat
Bracket (37) with two M10 x 70mm Carriage Bolts
(108), two M10 Washers (91), and two M10 Nylon
Locknuts (87).
T
ighten all of the M10 Nylon Locknuts (87) used
in this step.
91
32
1
10
37
108
87
87