Filter
Top Products
8
7. Press a 50mm x 75mm Inner Cap (58) into the top
of the Squat Upright (4). Press two 25mm Round
Outer Caps (120) onto the Upright.
Slide the Squat Upright onto the two indicated M10
x 65mm Carriage Bolts (110) in the Long Base
(106). Finger tighten an M10 Nylon Locknut (87)
onto each Carriage Bolt. Do not tighten the
Locknuts yet.
Press a 50mm x 75mm Inner Cap (58) into the top
of the Swivel Upright (5). Slide the Swivel Upright
onto the two indicated M10 x 65mm Carriage Bolts
(110) in the Long Base (106). Finger tighten an M10
Nylon Locknut (87) onto each Carriage Bolt.
Do not
tighten the Locknuts yet.
7
8
58
58
5
4
106
120
120
87
87
110
110
46
66
66
65
5
Adjustment
Hole
8. Press two Swivel Bushings (66) into the Swivel
Carriage (46).
Tighten an Adjustment Handle (65) into the Swivel
Carriage (46). Orient the Swivel Carriage as shown.
Slide the Carriage onto the Swivel Upright (5) and
engage the Adjustment Handle into an adjustment
hole in the Swivel Upright.