Filter
Top Products
14
29. Wrap the Lat Cable (88) around a 90mm Pulley
(78). Attach the Pulley and a Long Cable Trap (102)
to the
Top Frame (6) with an M10 x 50mm Bolt
(100) and an M10 Nylon Locknut (87).
Make sure
the Cable T
rap is turned to hold the Cable in the
groove of the Pulley.
33. Wrap the Butterfly Cable (69) over a “V”-pulley (55).
Attach the Pulley and a Long Cable
T
rap (102) to
the indicated bracket on the Butterfly Upright (3)
with an M10 x 60mm Bolt (18) and an M10 Nylon
Locknut (87).
Make sure that the Long Cable
T
rap is turned to hold the Cable in the groove of
the Pulley.
30. Remove the preattached 90mm Pulleys (78)
from the Pulley Plates (63).
Wrap the Lat Cable (88) around a 90mm Pulley
(78). Attach the Pulley and a Cable Trap (68) to the
second set of holes from the top of the Pulley
Plates (63) with an M10 x 50mm Bolt (100) and an
M10 Nylon Locknut (87).
Make sure the Cable
Trap is turned to hold the Cable in the groove of
the Pulley.
31. Attach the end of the Lat Cable (88) inside of the
Butterfly Top Frame (7) with an M10 x 67mm Bolt
(121), two M10 Washers (91), and an M10 Nylon
Locknut (87).
29
30
31
32
33
63
87
91
91
121
88
87
102
78
87
88
100
88
78
100
6
103
7
70
69
25
69
3
87
55
102
18
32. Locate the Butterfly Cable (69), which is the
shortest Cable. Attach the Cable to the Pivot
Bracket (70) on the Left Butterfly Arm (25) with an
M8 x 25mm Shoulder Bolt (103) and an M8 Nylon
Locknut (86).
86
68