Weider 831.153932 Home Gym User Manual


 
18.
Locate and open the parts bags labeled “CABLE
ASSEMBLY” and “PULLEYS.”
Lubricate the M10 x 165mm Bolt (95) with grease.
Attach the Swivel Cage (76) to the Swivel Carriage
(46) with the Bolt and an M10 Nylon Locknut (87).
Locate the Swivel High Cable (74), which is
3200mm long and has a ball on one end and a
threaded bolt on the other end. Remove the
upper 90mm Pulley (78) from the Swivel Cage (76).
W
rap the Cable around the Pulley
. Reattach the
Pulley to the Swivel Cage with the M10 x 45mm
Bolt (93) and the M10 Nylon Locknut (87).
11
16. Press a 40mm x 50mm Inner Cap (21) into the Right
Butterfly Arm (26). Wet the lower end of the Arm and
a Long Pad (54) with soapy water
. Slide the Long
Pad onto the Arm.
Attach the Press Handle (27) to the Right Butterfly
Arm (26) with two M8 x 20mm Button Head Screws
(51). Slide the Long Pad (54) down so that the bot-
tom is flush with the lower end of the Arm. Wet the
Press Handle with soapy water. Slide a Long
Handgrip (28) onto the Press Handle. Press a 25mm
Round Inner Cap (29) into the Press Handle.
Lubricate an M10 x 50mm Bolt (100) with grease.
Attach a Pivot Bracket (70) to the Right Butterfly
Arm (26) with the Bolt and an M10 Nylon Locknut
(87).
Do not overtighten the Locknut; the Pivot
Bracket must be able to pivot easily. Repeat this
step with the Left Butterfly Arm (25).
17. Lubricate an M10 x 80mm Button Head Bolt (104)
and both sides of two Plastic Washers (56) with
grease. Attach the Right Butterfly Arm (26) to the
Butterfly Frame (47) with the Bolt, the two Plastic
Washers, two Butterfly Caps (57), two M10
Washers (91), and an M10 Nylon Locknut (87) as
shown. Make sure that the recessed sides of the
Plastic Washers are fitted over the welded bush-
ing in the Butterfly Arm. Do not overtighten the
Locknut; the Butterfly Arm must be able to pivot
easily.
Repeat this step with the Left Butterfly Arm (25).
16
CABLE ASSEMBLY
74
18
78
87
93
76
87
17
IMPORTANT: Refer to the Cable Identification
Chart on page 26 for help identifying the
cables. Do not overtighten the bolts and
nuts attaching the pulleys. The pulleys must
be able to turn freely.
26
47
87
56
104
91
57
57
91
25
21
100
Lubricate
70
87
26
25
51
29
28
27
54
95
46