Filter
Top Products
12. Place two Weight Bumpers (51) over the indicated
holes inthe Weight Base (5). Slide a Weight Guide
(15) intoeach ofthe holes.
Attach the indicatedWeight Guide (15) to the Weight
Base (5) with a 3/8" x 2 3/4" Bolt(46), two 3/8" Flat
Washers (48), and a 3/8" Nylon Locknut(50).
Slide ten Weights (21) ontothe Weight Guides (15).
Make sure the Weights are turned so the pin
grooves point towards the floor.
Press a Weight Tube Bumper (18) intothe lowerend
of the Long Weight Tube (70). Slidethe Weight Tube
intothe center holes inthe Weights (21).
Slide a TopWeight (16) ontothe Weight Guides (15).
Note: Make sure the Top Weight is tumed so the
groove fits over the welded pin on the Weight
Tube (70).
13. Place the Weight Top Frame (66) on the indicated
brackets on the Uprights(1 and 2). Note: The four
Weight Guides (15) must be behind the Weight
Top Frame, as shown in step 14.
Attach the Weight Top Frame (66) tothe ButterflyTop
Frame (33) with two 3/8" x 2 3/4" Bolts(46), a
Support Plate with 4" center holes(94), and two 3/8"
Nylon Locknuts(50). Do not tighten the Nylon
Locknuts yet.
Attach the Weight Top Frame (66) to the bracketon
the ButterflyUpright (1) with two 3/8"x 2 3/4" Bolts
(46), a SupportPlate with 2 1/2" center holes (34),
and two 3/8" Nylon Locknuts(50). Do not tighten the
Nylon Locknuts yet.
14. Attach the Weight TopFrame (66) tothe Press Top
Frame (9) with one 3/8" x 2 3/4" Bolt(46), a Support
Plate with 4" center holes(94), and a 3!8" Nylon
Locknut (50). Slide a 3 1/2" Pulley (24) with a Cable
Trap (25) ontoa 3/8" x 4" Bolt(78). Insertthe Bolt
throughthe SupportPlate (94) and hand tightena
3/8" Nylon Locknut(50) onto it.
Attach the Weight Top Frame (66) tothe bracket on
the Press Upright(2) withtwo 3/8" x 2 3/4" Bolts(46),
a SupportPlate with 2 1/2" center holes (34) and two
3/8" Nylon Locknuts(50). Do not tighten the Nylon
Locknuts yet.
9
12
Pin
51
5
13 34_46
46 ,. _¢U-o'_'=_._ 50