Filter
Top Products
9.
Press a 2" Square Inner Cap (28) into the Press Seat
Frame (7).
Slide the bracketon the Press Seat Frame (7) onto
the indicated 5/16" x 2 1/2"Carriage Bolts(92) in the
Press Base (6). Hand tightentwo 5/16" Nylon
Locknuts(64) ontothe Bolts. Do not tighten the
Nylon Locknuts yet.
Attach the Press Seat Frame (7) to the Press Upright
(2) withtwo 5/16" x 2 3/4" Bolts(89), two 5/16"
Washers (36), and two 5/16" Nylon Locknuts(64). Do
not tighten the Nylon Locknuts yet.
36
10. Lubricatethe 3/8" x 3"Bolt (88). Attach the Leg Press
Lever (83) to the Press Base (6) with the Boltand a
3/8" Nylon Locknut(50). Do not overtighten the
Nylon Locknut; the Leg Press Lever must pivot
easily.
11. Place two Weight Bumpers (51) over the indicated
holesin the Weight Base (5). Slidea Weight Guide
(15) intoeach of the holes.
Attach the indicatedWeight Guide (15) to the Weight
Base (5) with a 3/8" x 2 3/4" Bolt(46), two 3/8" Flat
Washers (48), and a 3/8" Nylon Locknut (50).
Slide sixWeights (21) ontothe Weight Guides (15).
Make sure the Weights are turned so the pin
grooves point towards the floor.
Press a Weight Tube Bumper (18) intothe lowerend
of the ShortWeight Tube (17). Slide the Weight Tube
intothe center holesin the Weights (21).
Slide a TopWeight (16) onto theWeight Guides (15).
Note: Make sure the Top Weight is turned so the
groove fits over the welded pin on the Weight
Tube (17).
8