Filter
Top Products
52. Inserta 1/4"x 2 112"Carriage Bolt(45) throughthe
center hole in a Seat Plate (65). Attachthe Seat Plate
to a Seat (13) with two 1/4"x 3/4" Bolts (49),
Insert the 1/4" x 2 1/2" Carriage Bolt(45) intothe indi-
cated hole in the ButterflySeat Frame (14) end
secure it with a 1/4" Flat Washer (71) and a 1/4"
Nylon Locknut (68). Secure the other end of the Seat
(13) with a 1/4" x 2 1/2" Bolt (79) and a 1/4" Flat
Washer (71).
Attach the other Seat (13) to the Press Seat Frame
(7, not shown) in the same manner.
52
53. Press 3/4" Round Inner Caps (43) into the ends of the
Pad Tube (42) and the indicatedtube on the Front
Leg (20),
Insertthe Pad Tube (42) intothe indicated holein the
Small Leg Lever (41). Slide Foam Pads (30) ontothe
ends of the Pad Tube and the tube on the Leg Lever.
53
43 30
30
Tube
54. Press a 1 3/4" Square Inner Cap (35) into the indicat-
ed end of theAdjustmentTube (90).
Attach theAdjustment Tube (90) to the bracket (not
visible inthe drawing)on the backof the Leg Press
Plate (55) with a 5/16" x 2 1/2" Bolt(87), two 5/16"
Washers (36), and a 5/16" Nylon Locknut(64).
Attach the Leg Press Plate (55) to the Leg Press
Lever (83) byplacingthe AdjustmentTube (90) into
the bracket on top ofthe Leg Press Lever and secur-
ing itwith the Lock Pin (91). Note: The lip on the
Leg Press Plate must be on the upper edge.
54
55
35
55. Attach the Curl Pad (105) to the Cud Post(104) with
two 1/4" x 3/4" Bolts(49),
55
21