Filter
Top Products
1.
2,
Before beginning, make sure that you have read
and understood the information on page 4.
Locate and open the parts bag labeled "FRAME
ASSEMBLY."
See drawing la. Press a 2" Square Inner Cap (28)
intoeach end of the ButterflyBase (4). Presstwo 2"
Square Inner Caps (28) intothe Weight Base (5).
Insertfour5/16" x 2 1/2"Carriage Bolts(92) up
through the indicatedholes inthe ButterflyBase (4).
Inserta 3/8" x 3 1/2" Carriage Bolt (95) up through
the hole at the end of the ButterflyBase. Note: If the
Bolts fall out, secure them by putting a small
piece of tape over the head of each Bolt. Place the
ButterflyBase fiat on the floor.
See drawing lb. Attach the Weight Base (5) to the
ButterflyBase (4) with two 5/16" x 2 3/4" Bolts(89), a
SupportPlate with 3 1/2" center holes (93), and two
5/16" Nylon Locknuts(64). Do not tighten the Nylon
Locknuts yet.
Note: There are three kinds of Support Plates. The
main difference between them is the distance
between the holes. When you need a Support
Plate, find the type with holes that will fit over the
Bolts you are using.
See drawing 2a. Pressa 2" Square Inner Cap (28)
intothe end of the Press Base (6).
Attach a 3 1/2" Pulley (24) to each of the brackets on
theWeight Base (5) with a 3/8"x 1 3/4" Bolt(57) and
a 318"NylonJamnut (63).
Insertfour 5/16" x 2 1/2" Carriage Bolts(92) up
throughthe indicatedholes in the Press Base (6).
Inserta 3/8" x 2 1/2"Carriage Bolt (101) and a 318x
4" Carriage Bolt (102) up throughthe indicated holes
at the end of the Press Base (6).
See drawing 2b. Attach the Press Base (6) to the
Weight Base (5) with two 5/16" x 2 3/4" Bolts (89), a
SupportPlate with 3 1/2" center holes (93), and two
5/16" Nylon Locknuts(64). Do not tighten the Nylon
Locknuts yet.
la
28
lb 89
2a
2b
28
4
92
64
5
28
102
92 101
64
93
89
5