Filter
Top Products
31. Remove a Pro Pulley (26) from the bag labeled
"PULLEY BAG 2".
Identifythe Low Pulley Cable (75). It isapproximately
143 1/2"long and it has a ball on one end and a loop
on the other. Route the end with the loopthroughthe
slotin the cable guide on the ButterflyBase (4).
Routethe Low Pulley Cable (75) undera Pro Pulley
(26) as shown.Attach the Pro Pulleyand a Cable
Trap (25) to the bracket on the ButterflyBase (4) with
a 3/8" x 2" Bolt (54) and a 3/8" Nylon Locknut(50).
Make sure the Cable Trap is oriented as shown•
31
Guide
25
75
32. Wrap the Low PulleyCable (75) arounda 3 1/2"
Pulley (24) inthe directionshown.Attach the Pulley
and a Cable Trap (25) to the indicatedhole in the
ButterflyUpright(1) with a 3/8" x 4 3/4" Bolt (60) and
a 3/8" NylonJamnut (63). Note: Thread the Jamnut
only two turns onto the Bolt, since you will later
attach another Pulley to the Bolt. Make sure the
Cable Trap is oriented as shown.
32
63
33. Wrap the Low PulleyCable (75) over a 3 1/2"Pulley
(24) inthe directionshown.Attach the Pulley and a
Cable Trap (25) to the lower hole inthe Adjustable
Pulley Plates (23) with a 3/8" x 2" Bolt(54) and a 3/8"
Nylon Locknut(50). Make sure the Cable Trap is
oriented as shown.
33
54
\
34. Remove the 3/8" NylonJamnut (63) from the
3/8" x 4 3/4" Bolt(60) inserted intothe Butterfly
Upright (1) in step 32.
Wrap the Low Pulley Cable (75) arounda 3 1/2"
Pulley (24) inthe directionshown.Attach the Pulley
and a Cable Trap (25) to the 3/8" x 4 3/4" Bolt(60)
with the 3/8" NylonJamnut (63). Make sure the
Cable Trap is oriented as shown.
34
15