Filter
Top Products
46. Locate the Ab Cable (107). Route the small ball
on the Cable through the Leg Lever (4) and the
Right Seat Frame (3). Make sure the Cable is
over the rod in the Seat Frame.
Attach a 90mm Pulley (63) inside the Leg Lever
(4), over the Ab Cable (107), with an MIO x
65mm Bolt (77), two MIO Washers (99), two MIO
x 12mm Spacers (101), and an MIO Nylon
Locknut (90).
47. Attach a 90mm Pulley (63) inside the Right Seat
Frame (3), over the Ab Cable (107), with an MIO
x 45mm Bolt (80) and an MIO Nylon Locknut
(90).
48. Route the Ab Cable (107) through the Right
Upright (2) and under a 90mm Pulley (63). Attach
the Pulley and two Half Finger Guards (66) to the
Right Base (1) with an MIO x 50mm Bolt (64) and
an MIO Nylon Locknut (90). Make sure the
Finger Guards are oriented as shown.
49. Wrap the Ab Cable (107) over a 90mm Pulley
(63). Attach the Pulley, a Cable Trap (68), and
two Half Finger Guards (66) to the lower hole in
the indicated "U'-bracket (50) with an MIO x
50mm Bolt (64) and an MIO Nylon Locknut (90).
Make sure the Cable Trap and Finger Guards
are oriented as shown.
46
Large
Ball
47
48
49
107
90
90
Rod
77
63
80
5O
66
64
18