Filter
Top Products
12. Attach the Left Top Frame (36) to the Right Top
Frame (5) with four M8 x 78mm Bolts (82), two
M8 Washers (98), a Support Plate (31), and four
M8 Nylon Locknuts (91). Do not tighten the
Locknuts yet.
13. Attach the Left Top Frame (36) to the Left Upright
(26) with two M8 x 78mm Bolts (82), a Support
Plate (31), and two M8 Nylon Locknuts (91). Do
not tighten the Locknuts yet.
14. Orient the Butterfly Frame (14) as shown. Attach
the Butterfly Frame to the Right Upright (2) with
two M8 x 72mm Bolts (85), two M8 Washers (98),
and two M8 Nylon Locknuts (91). Do not tighten
the Locknuts yet.
Attach the Butterfly Frame (14) to the Right Top
Frame (5) with two M8 x 78mm Bolts (82), two
M8 Washers (98), and two M8 Nylon Locknuts
(91).
Tighten the M8 Nylon Locknuts (91) used in
steps 3-14.
Arm As sem b ly
15. Wet the lower end of the Left Butterfly Arm (6)
with soapy water. Slide a Large Foam Pad (15)
onto the Left Butterfly Arm.
Note: an entire grease packet should be used
for this step. Grease an M10 x 85mm Bolt (74)
and the indicated edges of two Arm Bushings (23)
with a grease packet. Attach the Left Butterfly
Arm (6) to the Butterfly Frame (14) with the Bolt
(74), an M10 Large Washer (100), the two Arm
Bushings, and an M10 Nylon Locknut (90). Make
sure the bolt head fits inside of the hole in the
Butterfly Frame.
Repeat this step with the Right Butterfly Arm
(7).
12
13
14
15
98
91
98
14
36
31
82
98
82
91
82
36
91
J
/
82
98
\
5
\
Grease
10