Filter
Top Products
41. Route the Weight Cable (110) over a 90mm
Pulley (63) and down through the Right Top
Frame (5). Attach the Pulley inside the Top Frame
with an MIO x 80mm Bolt (75), two MIO Washers
(99), two MIO x 19mm Spacers (102), and an
MIO Nylon Locknut (90).
42. Wrap the Weight Cable (110) under a 90mm
Pulley (63). Attach the Pulley, a Cable Trap (68),
and two Half Finger Guards (66) at the second
hole from the top of the two Pulley Plates (51)
with an MIO x 50mm Bolt (64) and an MIO Nylon
Locknut (90). Make sure the Cable Trap and
Finger Guards are oriented as shown.
43. Wrap the Weight Cable (110) over a 90mm Pulley
(63). Attach the Pulley to the indicated bracket on
the Right Top Frame (5) with an MIO x 45mm
Bolt (80) and an MIO Nylon Locknut (90).
44. Wrap the Weight Cable (110) over a 90mm Pulley
(63). Attach the Pulley and a Cable Trap (68) to
the indicated bracket on the Right Top Frame (5)
with an MIO x 45mm Bolt (80) and an MIO Nylon
Locknut (90). Make sure the Cable Trap is ori-
ented to hold the Cable in the groove of the
Pulley.
45. Set the M12 Washer (33) on top of the Weight
Tube (47). Thread the M12 Nut (49) all the way
onto the Weight Cable (110).
Thread the Weight Cable (110) into the Weight
Tube (47) a couple of turns.
41
75
<
110
43 Bracket
5
44 Attach
on
45
102
51
90
99
90
63
51
66
17