Filter
Top Products
27. Wrap the Press Cable (109) around a "V"-pulley
(62). Attach the "V"-pulley, two Half Finger Guards
(66), a Large Cable Trap (111), and an MIO
Washer (99) inside the bracket on the Left
Upright (26) with an MIO x 65mm Bolt (77) and
an M10 Nylon Locknut (90). Make sure the
Cable Trap and Finger Guards are oriented as
shown.
28. Wrap the Press Cable (109) around a 90mm
Pulley (63). Attach the Pulley, two Half Finger
Guards (66), a Cable Trap (68), and an MIO
Washer (99) to the Press Frame (29) with the
MIO x 135mm Bolt (70) used in step 26 and an
MIO Nylon Locknut (90). Make sure the Cable
Trap and Finger Guards are oriented as
shown.
29. Wrap the Press Cable (109) under a 90mm
Pulley (63). Attach the Pulley, two MIO Washers
(99), and two Half Finger Guards (66) inside the
bracket on the Left Base (25) with an MIO x
50mm Bolt (64) and an MIO Nylon Locknut (90).
Make sure the Finger Guards are oriented as
shown.
30. Wrap the Press Cable (109) over a 90mm Pulley
(63). Attach the Pulley and a Cable Trap (68) to
the Right Top Frame (5) with an MIO x 45mm
Bolt (80) and an MIO Nylon Locknut (90). Make
sure the Cable Trap is oriented to hold the
Cable in the groove of the Pulley.
27
90/
09
-111
/66
28
109
63
66 90
2
7O
99
66
64
109
30
80 68
63
9O
09
14