Filter
Top Products
49. Wrap the Swivel LowCable (72) over a 3 112"
Pulley(78). Attach the Pulley and a Cable Trap (68)
between the lowerset of holes in the "U"-bracket
(64) with a 3/8" x 2" Bolt (100) and a 3/8' Nylon
Locknut(87). Make sure that the Cable Trap Is
turned to hold the Cable In the groove of the
Pulley.
50. Attach the end of the Swivel Low Cable (72) inside
ofthe Short Base (2) with a 5/16" x 2 1/2" Bolt (59),
two 5/16" Washers (90), and a 5/16" Nylon Locknut
(86).
51. Locate the Squat Cable (73), which Is the only
remaining cable. Attach the eyelet end of the
Cable inside of the Long Base (120) with a 5/16" x
2 1/2" Bolt (59), two 5/16" Washers (90), and a
5/16" Nylon Locknut(86).
52. Wrap the Squat Cable (73) over a 3 1/2" Pulley
(78). Attach the Pulley,a Cable Trap (68), and two
314"Spacers (124) between the indicated brackets
on the Squat Slider (38) with a 318"x 3 1/4" Bolt
(96) and a 3/8" NylonJamnut (113). Make sure
that the Cable Trap Is turned to hold the Cable
In the groove of the Pulley.
49
90
59
59
18