Filter
Top Products
19. Routethe Swivel High Cable (74) throughthe Swivel
Upright(5) and over a 4 1/2" Pulley(119).Attachthe
Pulley insidethe Updghtwitha 3/8" x 2 3/4" Bolt
(101), two3/8" Washers(91), two 1/2"Spacers (89),
and a 318"Nylon Locknut(87).
Attacha 318"x 2 112"Bolt(18), two 3/8"Washers
(91), and a 3/8" Nylon Locknut(87) to the Swivel
Upright(5).
20. Remove the preettached 3 1/2" Pulleys (78) from
the Small Pulley Plates (31).
Wrap the Swivel High Cable (74) over a 3 112"
Pulley (78). Attach the Pulleyand a Cable Trap (68)
to the second set of holesfrom the top of the Small
Pulley Plates (31) with a 3/8" x 2" Bolt(100) and a
3/8" Nylon Locknut(87). Make sure the Cable
Trap Is turned to hold the Cable In the groove of
the Pulley.
21. Wrap the Swivel High Cable (74) over a 4 112"
Pulley (119). Attach the Pulley insideof the indicat-
ed bracket on theTop Frame (6) with 3/8" x 1 3/4"
Bolt (93) and a 3/8" Nylon Locknut(87).
22. Liftthe Weight Tube (43) and theTop Weight (45)
closesttothe Swivel Upright(5). Make sure that the
small pinon the Weight Tube is insideof the groove
under the TopWeight.
Inserta WeightPin (50) into the stackof Weights
(44). Place a 1/2"Washer (1) on top of the Weight
Tube (43). "tightena 1/2" Nut (118) halfway ontothe
end of the Swivel High Cable (74). Screw theend of
the Cable two full turnsintothe WeightTube. Then,
tightenthe Nut againstthe 1/2"Washer.
23. Locate the Swivel Cable (17), which Is 115 3/'8"
long and has an eyelet on each end. Attach the
Cable insidethe Top Frame (6) with a 5/16" x 2 112"
Bolt(59), two 5/16" Washers (90), and a 5/16"
Nylon Locknut (86).
19
2O
21
22
23
5 91 18
91_x_'__ 01
87_ 149 74
31
31
93
59
90 86
,.17
12