Filter
Top Products
12. Attach theTop Frame (6) betweenthe Squat Upright
(4) and the Swivel Upright(5) withfour 5/16"x 3 3/4"
Bolts(92), the two Short Frame Plates (52), and two
5/16" Nylon Locknuts(86) as shown. Do not tlghtsn
the Bolts and Locknuts yet.
Attachthe fourWeight Guides (42) to the Top Frame
(6) withtwo 3/8" x 6 1/2" Bolts(95) and two318"
Nylon Locknuts(87).
13. Presstwo 2"x 3" Inner Caps (58) into theTop Frame
(6) and the ButterflyTop Frame (7).
Attachthe ButterflyTop Frame (7) to the TopFrame
(6) with two 5/16" x 2 314"Bolts(85), two 5/16"
Washers (90), and two 5/16" Nylon Locknuts(86).
Do not tighten the Locknuts yet.
Attach the ButterflyTop Frame (7) to the Butterfly
Upright (3) withtwo 5/16" x 3 3/4" Bolts(92), two
5/16" Washers (90), and two 5/16" Nylon Locknuts
(86).
Tighten all of the 5/16" Nylon Locknuts (86) and
3/8" Nylon Locknuts (87) used In steps 2-13.
14. Open the parts bag labeled "ARM ASSEMBLY."
Press three 1 1/2"x 2" Inner Caps (21) intothe Leg
Lever (10). Attach the Eyebolt(116) to the Leg
Lever with a 3/8" Washer (91) and a 318"Nylon
Jamnut (113).
Lubricate a 3/8" x 2 1/2" Bolt (18) with grease. Turn
the Leg Lever (10) sothat the welded tab is on the
indicatedside, and attach the Leg Lever to the Seat
Upright (9) with the Bolt and a 3/8_ Nylon Locknut
(87). Do not overtlghten the Nylon Locknut; the
Leg Lever must be able to pivot easily.
15. Press a 2" x 2 1/2" Inner Cap (125) intothe
ButterflyFrame (47). Attachthe tethers on the two
=L"-pins w/Tether (60) to theButterflyFrame witha
#8 x 314"Screw (98).
Lubricatea 3/8" x 3" Bolt (107) withgrease. Attach
the ButterflyFrame (47) to the ButterflyTop Frame
(7) with the Boltand a 3/8" Nylon Locknut (87). Do
not overUghten the Nylon Locknut; the Butterfly
Frame must be able to pivot euUy.
12
92 52
5--
95t
/"_ 6
t_ 9_': i_v,_92
13 92_90
86 '8
58
i 90 85
14
87
21
21
116
15
21
125_
) -
10