Filter
Top Products
8
3. Attach Base A (6) and the Storage Post (27) to
Upright A (8) with two M8 x 75mm Bolts (48) and
two M8 Nylon Locknuts (40). Do not confuse
Upright A and Upright B. Locate the welded nut
to identify each Upright.
4. Attach Base B (7) to Upright B (9) with two M8 x
75mm Bolts (48), Support Plate B (28), and two M8
Nylon Locknuts (40).
Tighten the M8 Nylon Locknuts (40) used in
steps 1–4 now.
5. Slide a Weight Rest (11) into Upright A (8). Align
one of the holes in the Weight Rest with the hole in
Upright A. Insert a Small Adjustment Knob (25)
through Upright A and the Weight Rest. Tighten the
Knob into the welded nut.
Insert the other Weight Rest into Upright B (not
shown) in the same manner. Both Weight Rests
must be set at the same height.
6. Insert the Adjustment Tube (12) into one set of
adjustment brackets on the Uprights (8, 9). Be sure
the Adjustment Tube is oriented as shown and
that it is fully inserted into the adjustment
brackets on the Uprights.
6
3
4
5
8
48
27
40
6
48
40
9
28
7
11
8
Welded
Nut
Welded
Nut
25
Adjustment
Brackets
12
Pin
Pin
9
8